Actions

Distant Screws II Challenge Coin: Difference between revisions

From Rabbi Blog

mNo edit summary
Line 1: Line 1:
[[File:DS2-Heads.jpg|thumb|Heads: Logo + Distant Screws II  Jan\Apr 3307 53.2K (light years) ]][[File:DS2-Tails.jpg|thumb| Tails: A star for Evelyn's Light + The expedition route (Ross310 -> Evelyn's Light -> Colonia -> Qama)]]
[[File:DS2-Heads.jpg|thumb|Heads: Logo + Distant Screws II  Jan\Apr 3307 53.2K (light years) ]][[File:DS2-Tails.jpg|thumb| Tails: A star for Evelyn's Light + The expedition route (Ross310 -> Evelyn's Light -> Colonia -> Qama)]]
==About==
==About==
Placeholder
* [https://www.drewwagar.com/elite-dangerous-saga/evelyns-story/ Evelyn's Story]
* [https://forums.frontier.co.uk/threads/memorial-for-my-little-commander.538342/ JelloWiggler's Frontier Forums Thread]
** [https://forums.frontier.co.uk/threads/memorial-for-my-little-commander.538342/page-5#post-8318602 Where FDev gets involved]
** [https://forums.frontier.co.uk/threads/memorial-for-my-little-commander.538342/page-8#post-8704212 FDev Delivers]
* [https://www.edsm.net/en/expeditions/participants/id/126/name/Distant+Screws+II%3A+Expedition+for+Evelyn Expedition Page on EDSM]
* [https://www.edsm.net/en/system/id/56734905/name/Evelyn%27s+Light Evelyn's Light Position on EDSM]


==ReadMe==
==ReadMe==

Revision as of 10:08, 4 March 2021

Heads: Logo + Distant Screws II Jan\Apr 3307 53.2K (light years)
Tails: A star for Evelyn's Light + The expedition route (Ross310 -> Evelyn's Light -> Colonia -> Qama)

About

ReadMe

A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.

The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.

The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.


Printing Suggestions

    Scale to 60mm x 60mm x 8mm (or 10mm)
    Super Quality

1) With trees: On an edge - will require sanding and clean up. 2) In halves:

    Duplicate the STL on the bed
    Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
    Flip one of the faces
    Print
    Glue together
    Sand edge as needed with 220g and 500+



Created by RabbiBob 3/1/2021 w/ Blender 2.9.x

Download

Directions