Distant Screws II Challenge Coin: Difference between revisions

Revision as of 11:18, 3 March 2021

About

Place holder page

ReadMe

A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.

The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.

The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.

Printing Suggestions

    Scale to 60mm x 60mm x 8mm (or 10mm)
    Super Quality
    No Infill

1) With trees: On an edge - will require sanding and clean up. 2) In halves:

    Duplicate the STL on the bed
    Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
    Flip one of the faces
    Print
    Glue together
    Sand edge as needed with 220g and 500+

Created by RabbiBob 3/1/2021 w/ Blender 2.9.x

Download

Download: Zip file

Directions

@@ Line 3: / Line 3: @@
-[[File:DS2-Heads.jpg]][[File:DS2-Tails.jpg]]
+[[File:DS2-Heads.jpg|thumb]][[File:DS2-Tails.jpg|thumb]]
 ==ReadMe==
-<pre>
 A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.
@@ Line 33: / Line 33: @@
 w/ Blender 2.9.x
-</pre>
 ==Download==
 * Download: [http://www.rabbibob.com/cstrike/ED/LSN%20DISTANT%20SCREWS%20II%20COIN.zip Zip file]