Actions

Distant Screws II Challenge Coin

From Rabbi Blog

About

Place holder page


DS2-Heads.jpg
DS2-Tails.jpg

ReadMe

A how-to for printing the 3D LS DS II Challenge Coin for anyone that was on the 2021 Distant Screws II Expedition.

The front-side features the classic LS Logo, the expedition name, dates and the waypoint distances traveled.

The backside features the four points of the journey (ROSS310-EVELYNS LIGHT-COLONIA-QAMA) and a star to honor Evelyn Faye Roy.


Printing Suggestions

    Scale to 60mm x 60mm x 8mm (or 10mm)
    Super Quality
    No Infill

1) With trees: On an edge - will require sanding and clean up. 2) In halves:

    Duplicate the STL on the bed
    Sink both below the bed to 1/2 the Z width (-4mm or -5mm)
    Flip one of the faces
    Print
    Glue together
    Sand edge as needed with 220g and 500+



Created by RabbiBob 3/1/2021 w/ Blender 2.9.x


Download

Directions